The section contains modules for platforms: plug-in units (Pi-U), backplanes and power supply units. Plug-in units have front panels according to IEEE 1101.10 standard, also there is a variant IEEE 1101.1, and without front panel – for deep plug inside platforms providing keyboard and display on its front panel.
|
-
Quadrature Modulators
( 2 Articles )
This section contains modules of vector (qudrature) modulators based on plug-in units (Pi-U), designed for use in platforms. The following basic parameters are listed in the table below. - RF-block on which Pi-U is based;
- Base PCB for Pi-U (the board providing data and control interface between RF-block and backplane);
- Pi-U dimensions:
- width, HP (1HP=5.08 mm or 0.2 in);
- height, U (1U=44.45 mm or 1.75 in);
- depth, mm.
Pi-U Based Quadrature Modulators
-
RF Signal Generators
( 2 Articles )
This section contains RF Signal generator modules based on plug-in units (Pi-U), designed for use in platforms. Basic parameters are listed in the table below. - RF-block on which Pi-U is based;
- Base PCB for Pi-U (the board providing data and control interface between RF-block and backplane);
- Pi-U dimensions:
- width, HP (1HP=5.08 mm or 0.2 in);
- height, U (1U=44.45 mm or 1.75 in);
- depth, mm.
Pi-U Based RF Signal GeneratorsProduct | Base RF Block | Base PCB | Form factor | Description | | LNO-HP01M-P3U4HP220E | LNO-HP02M-RF | FXPUPI-01RF-PCB | 3U 4HP 220mm | Pi-U Based RF Signal Generator 62.5 MHz - 8 GHz up to +20 dBm for FXP Platform (front panel with Ext Ref IN connector) | | LNO-LP01M-P3U4HP220E | LNO-LP01M-RF | FXPUPI-01RF-PCB | 3U 4HP 220mm | Pi-U Based RF Signal Generator 62.5 MHz - 8 GHz up to +20 dBm for FXP Platform (front panel with Ext Ref IN connector) |
-
Baseband I/Q Generators
( 1 Article )
This section contains vector generators modules (quadrature I/Q generators) based on plug-in units (Pi-U) which forms complex signal, i.e. I and Q channel. These units are used in platforms. Here listed the description for the parameters used in the tables. - Analytical signal (I+jQ) bandwidth (baseband);
- DAC clock frequency;
- DAC resolution, bits;
- RAM capacity, Mbytes;
- Hardware interpolation range;
- Resampling step;
- SINAD (Signal-to-Noise and Distortion);
- Pi-U dimensions:
- width, HP (1HP=5.08 mm or 0.2 in);
- height, U (1U=44.45 mm or 1.75 in);
- depth, mm.
Baseband I/Q GeneratorsProduct | I/Q BW | DAC Clk | Resolution | RAM | Interp. | Interp.
Step | SINAD | Description | | DVM-01M-P3U4HP220 | 66 MHz | 132 MHz | 12 bit | 8 MB | 1..4096 | 2x | 70dB@10MHz BW | Baseband I/Q Generator (Vector Modulator) with hardware interpolator, NCO, DDC, hardware QAM, FM and PM |
-
Power Supply Units
( 2 Articles )
This section contains power supply plug-in units (AC-DC, DC-DC converters) designed for platforms and RF-blocks. Parts are specified by the following parameters. - Total output power;
- Output voltages and currents;
- Pi-U dimensions:
- width, HP (1HP=5.08 mm or 0.2 in);
- height, U (1U=44.45 mm or 1.75 in);
- depth, mm.
Power Supply Plug-in Units
-
Backplanes
( 1 Article )
This section contains backplanes for platforms. They are specified by the following general parameters listed in the table. - N of available slots;
- System clock frequency;
- V(I/O) supply voltages.
Backplanes for platformsProduct | N of Slots | System Clk | V(I/O) | Description | | FXPBPL-01M-PCB | 8 | 33/66 MHz | 2.5/3.3V | Backplane for FXP Platforms, 5x 64-bit Slots + 3x 8-bit Slots |
|
