Newsflash
The site is under construction at the moment. You can visit it a bit later. We shall present our full product range as soon as possible. To learn more about our products contact us by e-mail or phone, we will be glad to answer your questions.
Products & Services
switch_ru.png, 1 kB
advantex.ru
LNO-HP01M-P3U4HP220E - RF Synthesizer Plug-in Unit Print E-mail

RF Signal Generator Plug-in Unit 62.5 MHz – 8 GHz, +20 dBm

LNO-HP01M-P3U4HP220E - RF Synthesizer Plug-in Unit LNO-HP01M-P3U4HP220E - RF Synthesizer Plug-in Unit
RF Signal Generator Pi-U based on LNO block (see “IF/RF Blocks – RF Synthesizers” section). It is designed for use in FXP platforms. Two connectors are located on the front panel – RF output and auxiliary external reference input (“E” suffix).

Features
  • RF output frequency range: 62.5 MHz – 8 GHz;
  • RF output level range: -10..+20 dBm;
  • Internal or external reference;
  • Control interface: FXP;
  • Form-factor: Pi-U, 3U 4HP 220 mm.
Read more...
 
AVM4-01M-P3U4HP220E - I/Q Modulator Plug-in Unit Print E-mail

RF Vector Modulator 100 MHz – 4 GHz

AVM4-01M-P3U4HP220E - I/Q Modulator Plug-in Unit AVM4-01M-P3U4HP220E - I/Q Modulator Plug-in Unit
Quadrature modulator plug-in unit (RF I/Q Modulator) with output frequency range from 0.1 to 4 GHz based on AVM RF-block (see “IF/RF Blocks – I/Q Modulators” section). It is designed for use in FXP platforms. I, Q, LO (suffix “E”) inputs and RF output are located on front panel.

Features
  • RF output frequency range: 100 MHz – 4 GHz;
  • AGC-controlled output level: -10..+10 dBm;
  • Baseband: 300 MHz;
  • RF output multi-path filtering block;
  • Control interface: FXP;
  • Form-factor: Pi-U 3U 4HP 220mm.
Read more...
 
LNO-HP30M-RF - RF Synthesizer Print E-mail

RF Synthesizer 4MHz – 8GHz with output level up to +27dBm

Wideband frequency synthesizer (RF signal generator) with output frequency range from 4 MHz to 8 GHz, high frequency resolution and high output signal level. Output power is variable and AGC controlled with digital compensation system based on calibration data written in memory of the device. Synthesizer also has multi-path filtering block for additional harmonic suppression. Device is digitally controlled via SPI interface. Frequency tuning can be dynamically programmed within all specified frequency range. High output signal level allows the device to be used as a Local Oscillator (heterodyne) for passive balance mixers when more than +13 dBm required for linearity of the path. It also can be used for nonlinear distortion parameters measure of high-power output stages: one-decibel compression point – P1dB and intermodulation intercept point IP3 (with aid of two synthesizers for

RF Synthesizer 4 MHz - 8 GHz, +27 dBm RF Synthesizer 4 MHz - 8 GHz, +27 dBm
“pure” two-tone signal generation).

Features
  • RF output frequency range: 4 MHz – 8 GHz;
  • Min. frequency step: <0.001 Hz;
  • RF output level: up to +27 dBm;
  • Phase Noise: less than −121 dBc/Hz (@ 10kHz offset @ 1 GHz).
Read more...
 
FXPPSU-02M-P3U8HP220 - Power Supply Plug-in Unit Print E-mail

Power Supply Pi-U (AC-DC Converter)

Power supply unit (AC-DC Converter) – converts 220 AC to the number of voltages supplied to the FXP backplane (+3.3VD, +5VD, +12VD, -12VD, +5VA, +12VA, -12VA). Power supply unit has separate outputs for analog and digital supplies and grounds (GNDA and GNDD), ac-isolated from each other. It has filtering blocks at analog power outputs.

FXPPSU-02M-P3U8HP220 - Power Supply Plug-in Unit FXPPSU-02M-P3U8HP220 - Power Supply Plug-in Unit

Features
  • Total output power: 125 W;
  • Connector type: H15M (DIN 41612);
  • Output voltages (digital): +3.3, +5, +12, -12 V;
  • Output voltages (analog): +5, +12, -12 V;
  • Form-factor: Pi-U 3U 8HP 220 mm;
  • Indication on the front panel: “Power ON”, “Error”.
Read more...
 
<< Start < Prev 1 2 Next > End >>

Page 2 of 2
Advantex LLC, 2004-2022